Phase One IQ2 User's Guide download pdf (Page 112)

112

9.6 Mirror Up Delay

To change from the Self-timer to the Mirror Up setting, press the shutter

button so the mirror goes into the upright position. Once the set time

has expired the shutter will release, and the mirror will return to the

lowered position. Separately purchased electronic cable release RE401

can be used to eliminate camera shake.

When using autofocus the operational method is the same as 1 to 3

when using M.UP and autofocus.

1-3 (reference steps 1-3 in the Mirror Up Autofocus method).

4. Press the Self-timer button and turn the front dial to ON.

5. Turn the rear dial to select the time needed. 0.5/1 seconds to 10

seconds allows for increases by the second, 10 to 90 seconds increases

by 10 seconds per turn. For 2 to 10 minutes the value increased by the

minute and 10 to 60 minutes increases by 10 minutes per turn.

6. Line up the photograph through the viewnder and half press the

shutter button to ensure the focus and framing is correct.

7. Full-press the shutter button and the mirror will go to the upper

position, then after the set time the shutter will release and the mirror

will return to the lowered position.

Electronic Shutter Release Contact

For Mirror Up, long exposure, or slow shutter shooting, use the

electromagnetic cable release 70258 (1 meter) or 70259 (5 meters). The

multi-pin remote terminal on the side of the camera is covered by a cap

that protects the contacts when not in use. Please remove cap and

insert the remote plug carfeully until it ‘clicks’ into postion.

Eyepiece Shutter

Close the eyepiece shutter when there is a strong light source behind

the camera.

80mm

1:28

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 176 177

No comments

Phase One IQ2 User's Guide Page 112