Phase One IQ2 User's Guide download pdf (Page 40)

NOTE:

When the exposure is compensated

in the Manual mode, the difference

between the metered value and the

compensated value will be displayed

on the viewnder LCD. In the B (Bulb)

mode, the difference with the metered

value is not displayed.

Increment of the aperture and shutter

speed value can be set at either 1/3 or

1/2-stop.

The assignments of the front and rear

dials can be swapped.

Rotation direction of the dials to

change the values can be altered.

The selected aperture and shutter

speed can be locked.

NOTE:

When the set value matches with the

metered value, the difference indicator

will show “0.0”.

Manual Mode (M)

This mode is used to set both the aperture and shutter speed for total

exposure control. Varying shutter speeds can be selected, including

“bulb”, “tIME” and manually from 60 mins to 1/4000 sec. Aperture

values can be set from maximum to minimum aperture.

1. Turn the exposure mode setting dial to “M” (Manual) position.

2. Turn the rear dial to set the desired aperture.

3. Turn the front dial to set the desired shutter speed.

4. When the shutter release button is half pressed, the difference

between the present settings and the metered value is displayed in the

viewnder’s LCD panel. The value is displayed in 1/3 stop increments

within a range of ±6 EV.

When the difference between the set value and the metered value is

greater than ±6EV and the set value is lower than the metered value,

the indicator in the viewnder LCD shows “– u –.” Contrarily when the

set value is higher than the metered value, the indicator shows “– o –.”

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 176 177

No comments

Phase One IQ2 User's Guide Page 40