Phase One IQ2 User's Guide download pdf (Page 115)

115

9.10 Self-Timer Mode

The default setting for the Self-Timer mode to release the shutter is 10

seconds after the shutter release button is pressed. The self timer lamp

ashes slowly for the rst 7 seconds, and then ashes quickly for the

last 3 seconds before the shutter is released. This function can be used

to avoid camera shake, to take group photos or for self-portraiture.

1. Mount the camera on a tripod.

2. Switch the shutter release mode selector to the (self timer mode).

3. Turn the front dial, and set the self-timer mode to ON.

4. Check the view by looking through the viewnder. Make sure that the

focus is correct, press the shutter release button and the shutter will be

released after 10 seconds.

Changing the Self-Timer Duration

1. Press the Self-Timer button to activate this function.

2. Turn the rear dial to change the duration of the Self-Timer. 0.5/1

seconds to 10 seconds allows for increases by the second, while 10

to 90 seconds increases by 10 seconds per turn. For 2 to 60 minutes

increases by 10 minutes per turn.

Releasing Self-Timer mode

1. Press the Self-Timer button to activate this function.

2. Turn the front dial to “OF”

NOTE

To release the self timer while it is

operating, turn off the power (by

setting the drive dial to L)

NOTE:

In the Self-timer setting, put the

drive dial to M.UP (mirror up) mode.

Should you wish to operate with

mirror up and delay, simply switch

the drive dial to M.UP (mirror up)

mode in the Self-timer setting.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 176 177

No comments

Phase One IQ2 User's Guide Page 115